09:37
Review of the YONHAN Smart 12/24V Battery Charger.
12:48
Using the Launch CRP919EBT to Diagnose and Repair an Evap Flow During Non-Purge with Code P0496.
31:07
The Benefits of Upgrading to Idoing Android 10.3in Head Unit in Your 2009-2015 Camaro
06:20
Stop Using Tongue & Groove Channellock Pliers Incorrectly.
08:32
Opening Up a 2007 Jeep Wrangler Throttle Body.
21:57
I Compare the Xtool D8BT, D8W, and D9S Pro to see what the Differences Are.
10:22
Machining a Smaller Radius on a Scope Mount to Fit Barrel Properly.
08:18
π₯Big Newsπ₯ Xtool D9S & D9S Pro Ver.2.0 is NOW FCA AutoAuth Compliant.
22:12
The Beretta A300 Ultima Patrol is Probably the Best Semi-Auto Shotgun for the Money.
08:49
Xtool D9S Pro Actuation Test and Special Function Walkthrough on a 2016 Chevy Sonic.
08:16
How to Replace the Turn Signal Lever Multifunction Switch on a 2013 Camaro in less than 10 Min.
27:22
Launch x-431 Pro3 Ace vs the Launch CRP919EBT. Which one Should You Buy?
08:39
The NEW $23 SK Pliers Wrench and How I Use Them.
08:49
Hidden Custom Settings the Launch CRP919EBT Allows you to Change on a 2015 Lexus NX200t.
18:24
Easy Fix Camaro A/C Blows Cold then Starts Blowing Fog or Smoke From Vents then Stops Blowing.
11:55
Will the Autel MS906 Scan Tool Fully Work after the Subscription Expires? Lets Find Out.
35:40
The Launch x431 Pro3 Ace Elite compared to the Xtool D9S Pro. Which one should you buy?
26:06
Machining a Pole Lock for the Navarre Kayak Anchor Stick Mount using the Lathe and Mill.
08:11
Launch CRP919EBT Active Test and Special Functions on a 2010 Impala.ππΌ
05:18
Xtool D8BT Active Test and Special Functions on a 2010 Impala. π§°πͺπ§π¨
07:24
How to Plug a Tire using the VEHICLEX Tire Plug Kit.π§°πͺπ§π¨
15:29
Complete Walkthrough of the NEW KINGBOLEN BM580 Battery Tester.βοΈβοΈβοΈβοΈ
12:03
Walkthrough of the Xtool D9S Pro on 2013 Camaro showing the Active Test and Special Functions.
05:06
OEDRO Off Road Floor Mats in our 2011 Tacoma. How do they Fit?
18:23
2006 Nissan Murano A/C Clutch will Not Engage. No parts Required.
04:33
How to Use a Left-Handed Drill Bit to Extract a Broken Screw from a Tacoma Antenna Mast.
14:44
How to Install a Digital Hardwire Kit for a Dash Cam. 2011 Toyota Tacoma.
08:26
Pressurizing another Aerosol Can to Failure. How much Pressure did this One Hold?
10:27
The Launch CRP123I V2.0 Budget Scan 4 System Scan tool with 7 Resets and FREE Lifetime Updates.
10:09
Test and Special Functions of the Launch x431 Pro3 Ace on a 2013 Camaro.
06:54
Walkthrough of the Xtool D9S Pro on a 2007 Wrangler Showing the Active Test and Special Functions.
38:45
2007 Jeep Wrangler Evap Temp Sensor Diagnosing and Replacement. Got my Cold AC back.
18:05
Max Pressure an Aerosol Can will Hold Before Failure.
08:28
Walkthrough of the Launch CRP919EBT on a 2011 RAM 1500 Showing the Active Test and Special Functions
16:12
New Features on the Launch Pro3 ACE Elite Scan Tool, and its EV, HD Truck, and Motorcycle Ready.
14:56
Pulsar GX400BN Dual Fuel Generator Full Load Test on Propane and Oil Inspection. Part 2.
21:35
Pulsar GX400BN Dual Fuel Generator 4.5hr. Break in on Propane and Oil Change. Part 1.
20:55
XTOOLS Top of The Line D9S Pro Scan Tool.
12:48
The BOSSCOMM IF-745 All System Scan tool with 6 Special Functions and Free Lifetime Updates.
11:39
2007 Jeep Wrangler JK Gets an Upgraded Aluminum Throttle Body. Lightening Bolt Symbol Fix.
53:37
Detailed 2010 Impala Rack and Pinion Replacement the Easy Way.
15:51
How to Easily Install a Schrader Valve on any Can to make It Refillable without Drilling or Torch.
16:17
Detailed 2013 Jeep Patriot Blend Air Door Actuator Replacement and Calibration.
23:18
Overview of the Champion 5500W Wireless Remote Generator. Model # 201351
10:54
Review and Installation of the Streamlight TL-Racker on a Mossberg 590A1 Shotgun.
19:15
Review of the Arpha D24 4K Dual Dash Cam with Touch Screen and Voice Commands.
08:49
Removing and Installing the Driver Side Lower HAVC A/C Duct on a 5th Gen Camaro.
23:10
RAM 1500 With ABS Sensor Code C0031-1D?
10:24
Walkthrough of the Xtool D8W on a 2021 Chevrolet Equinox.
07:52
How Good is the VOGMA VMONSTER V7 Air Duster/Vacuum?
13:28
Review of the MUCAR Driverscan Bi-Directional Scan Tool and Performance Calculator.
08:31
Taking a quick look at the TEKTON 22 Piece HEX Driver Set. DHX91301
10:01
Machining a GM LS Engine Front Timing Cover Alignment Tool on the Lathe.
01:00
Removing the Hormonic Balancer on a 4.3, 4.8, 5.3, LS Gen 3 Engine the Easy Way.
15:40
Why I chose the 22 piece Tekton Screwdriver Set over other brands?
02:28
Upgrading the Camaro Fog Light with AUTOONE LED Bulbs.
23:52
Injector Replacement on a 2007 Jeep Wrangler JK with the 3.8L Engine due to a Misfire.
11:55
Fast and Easy Washer Pump Replacement on 204-2018 Silverado / Sierra.
39:51
2016 GMC Sierra / Silverado High Speed Wipers Do Not Work. $10 Fix.
11:28
2007 Jeep Wrangler with a High Vibration on Acceleration. What fixed it?
X
About
Hi,
My name is Chris and shortly after high school I became an ASE certified Master Auto Mechanic. After doing that for a few years I became an A&P licensed airplane mechanic for a major airline. I realized a few years into switching to working on airplanes I missed working on cars and keeping up with automotive technology, so I started responding to neighbors' ads on Facebook that needed automotive maintenance help and the rest is history.
Now years later due to word of mouth I have a steady client list that keeps me busy 1 or 2 days each week. So, on my days off from my full-time job I am normally doing a small automotive job or two and if I think it might help some people, I film many of them.
Besides the auto maintenance videos I also have the random videos I think people might find interesting whether it is laser engraving, 3d printing or a simple tool review.
Please subscribe and help me keep this channel going and with your feedback we can grow together.
Tags