02:58

Alumni visit BTC Instrumentation (13 June 2016)

03:15

Alumni visit BTC Instrumentation (June 2016)

12:01

caSCADA system PID control demo

05:35

Model K-30 carbon dioxide sensor demonstration

03:36

Raspberry Pi-based SCADA prototype working

05:53

Miniature AC power grid substations -- part 5 (opening CT test switch to simulate bus fault)

04:10

Miniature AC power grid substations -- part 4 (manual trip demo)

05:17

Miniature AC power grid substations -- part 3 (external fault w/o trip)

06:09

Miniature AC power grid substations -- part 2 (bus fault demo)

07:44

Miniature AC power grid substations -- part 0 (overview)

06:45

Miniature AC power grid substations -- part 1 (bus topologies)

02:28

Marimba bar tuning

14:22

Alumni visit BTC Instrumentation

02:18

Meriam HART communicator

01:09

Inverted classroom recorded stop-motion style Oct 7, 2014

02:16

Miniature three-phase AC power grid (part 3 -- time overcurrent trip)

01:32

Miniature three-phase AC power grid (part 2 -- inst. overcurrent trip)

01:45

PLC/HMI timer display for a protective relay test set

01:12

Three-phase sequence shown on an oscilloscope

01:22

Miniature three-phase AC power grid (part 1 -- all stations online!)

04:28

Current transformer circuit "stab" test

03:43

Current transformer polarity check using a battery and meter

04:08

Reading Modbus registers from an SEL-551 protective relay

03:44

Miniature three-phase AC power grid (part 0 -- prelim. demo)

01:09

High turbine speed safety shutdown system

01:40

High air pressure safety shutdown system

04:13

Synchronizing AC generators -- Part 4 (phase deviation)

04:48

Synchronizing AC generators -- Part 2 (strobe light view)

04:04

Synchronizing AC generators -- Part 3 (sync and unsync)

05:05

Synchronizing AC generators -- Part 1 (introduction and sync lamps)

10:37

WirelessHART fish hatchery instrumentation (part 3)

05:08

WirelessHART fish hatchery instrumentation (part 2)

03:24

WirelessHART fish hatchery instrumentation (part 1)

04:08

Self excited induction generator (part 2)

03:21

Self excited induction generator (part 1)

03:43

PLC online display of variables -- a caveat!

06:46

BTC Perry Center fish hatchery -- new instruments!

02:15

RC servo controlled by a digital potentiometer (part 3)

01:17

RC servo controlled by a digital potentiometer (part 2)

01:17

RC servo controlled by a digital potentiometer (part 1)

04:09

Smart Wireless Gateway extended variable mapping

10:38

WirelessHART Smart Gateway tour

03:24

Rosemount WirelessHART installation

07:16

Ethernet hubs versus switches

01:58

Thermosiphon heat exchange process (with Barbie)

05:15

Allen-Bradley MicroLogix 1100 PID loop controller setup -- part 2 (analog input calibration)

07:42

Allen-Bradley MicroLogix 1100 PID loop controller setup -- part 0 (overview)

07:00

Allen-Bradley MicroLogix 1100 PID loop controller setup -- part 1 (ranging and PID action)

04:34

Stroboscope demonstration

02:53

Networked motor start/stop simulation using two PLCs

00:51

Troubleshooting a furnace temperature controller problem -- part 3

00:22

Troubleshooting a furnace temperature controller problem -- part 4

00:17

Troubleshooting a furnace temperature controller problem -- part 2

00:33

Troubleshooting a furnace temperature controller problem -- part 1

01:24

Infra-red thermography demo -- residual image of a warm object

01:31

Infra-red thermography demo -- electrical tape on a hot pan

01:02

Infra-red thermography demo -- IR window

00:29

Infra-red thermography demo -- glass opaque to IR light

01:01

Infra-red thermography demo -- quick calibration checks

04:40

Pump flow versus horsepower